Ak47 Pin Removal Without A Press Part 4 Youtube Removing barrel pins from an ak47. some are easy, some are not. share the video and subscribe!. What i do (and it runs a similar risk) is to vise the barrel trunnion pin down with a 1 4" long punch against one end of the pin and put a plate between the punch and the vise jaw. i tighten the vise, then put a 1 4" x 2" x 3" plate against the side of the vise jaw, then whack it with a hammer. some have suggested using a hardwood mallet, and i.
Ak47 Ak47gn Fix Stock Poland Deactivated Assault Rifle Without Removing barrel pins from an ak47. some are easy, some are not. share the video and subscribe!. This short clip shows removing a barrel pin and barrel from an amd 65. the tools used in the video have been updated since i made this video, but they still. For aks there is multiple thread patterns. 14x1 is one as is 24x1.5 among a couple others. if they are needing a brake device to put something ontop for their suppressor its an unique design & if you consider the detent pin gets stuck in such a way critically that you need to jimmy it out in very hard uncomfortable ways, its 100% their design being crap and not you. Reactions. 29. jun 2, 2010. #8. hammer and punch.drill a hole into a block of 2x4 for the pin to pass through and lay the barrel pin over the hole and whack the pin with the punch.use a short stubby punch that is slightly smaller than the pin.this keeps the punch from breaking.try taping the barrel receiver stub to the wood to keep it in place.
Comments are closed.