Barrel Sliding Knot Diy Tutorial Knot Bracelet Diy K Simple adjustable sliding knot bracelet tutorial. follow along and make your own with this quick and simple design!music thanks to ikson! song is ‘harmony’ 💜. About press copyright contact us creators advertise developers terms privacy policy & safety how works test new features nfl sunday ticket press copyright.
Barrel Sliding Knot Diy Tutorial Make And Fable Knot Bracelet 3.bring the tail down to create a loop. 4.take the tail underneath all the cords. 5.wrap around all of the cords three times, working over the loop. 6.then bring the tail up through the loop. 7.pull firmly, but so the cord can still move through the knot. 8.open the bracelet so its just wide enough to get on (tightening the knot will increase. Beebeecraft: shrsl 1nz9d | coupon: opal5 | free ship on orders $25 (allow 2 4 wks) hey beautiful! it’s gina from orchidandopal . in. Scissors. measuring tape. lighter or cord burner. optional: finish off the ends of the cords with additional spacer beads, as shown above, and use a lighter, or a cord burner, to melt the ends of the cord next to the knots. the bracelet pictured with the lime green cord is made with a single strand of 1mm cord, but i also show you how to make. To get started, lay the knot cord on top of the base cord. holding the knot cord about 1 to 2 inches from the end, make a loop. hold the loop in place with your index finger and thumb by pinching it against the base cord. you will be using the cord that is pointing down in the picture for the next steps. lisa yang.
Comments are closed.