Daikin Inverter Split Ac Wiring Connection Daikin Split Orethickness 0.031 inch (0.8mm) (c1220t o)3) use separate thermal insula. unit installationinstalling the mounting platethe mounting plate should be installed on a wall. hich can support the weight of the indoor unit.temporarily secure the mounting plate to the wall, make sure that the plate is completel. Carry out the drain piping. the diameter of the drain pipe should be greater than or equal to the diameter of the connecting pipe (vinyl tube; pipe size: 13 16”; outer dimension: 1 1 4”). keep the drain pipe short and sloping downwards at a gra dient of at least 1 100 to prevent air pockets from forming. slope, .
Daikin Inverter Split Ac Wiring Connection Daikin Split 1) drill a feed through hole with a 3 1 8 inch (80mm) diameter through the wall at a downward angle toward the outside. 2) insert a wall embedded pipe into the hole. 3) insert a wall hole cover into wall pipe. 4) after completing refrigerant piping, wiring, and drain piping, caulk the pipe hole gap with putty. 3. Install the mounting plate temporarily. level the mounting plate. mark the centres of the drilling points on the wall using a tape measure. position the end of tape measure at symbol " ". finish the installation by securing the mounting plate on the wall using m4×25l screws (field supply). class 15~42 class 50~71. Fix the unit in place securely using foundation bolts, as in the figure. (prepare 4 sets of 5 16 inch (m8) or 3 8 inch (m10) foundation bolts, nuts and washers; all sold separately.) it is best to screw in the foundation bolts until their ends are 3 4 inch (20mm) from the foundation surface. • make sure that all wiring is secured, the specifi ed wires are used, and that there is no strain on the terminal connections or wires. improper connections or securing of wires may result in abnormal heat build up or fi re. • when wiring the power supply and connecting the wiring between the indoor and outdoor units, position the wires so.
Wiring Diagram Daikin Inverter Fix the unit in place securely using foundation bolts, as in the figure. (prepare 4 sets of 5 16 inch (m8) or 3 8 inch (m10) foundation bolts, nuts and washers; all sold separately.) it is best to screw in the foundation bolts until their ends are 3 4 inch (20mm) from the foundation surface. • make sure that all wiring is secured, the specifi ed wires are used, and that there is no strain on the terminal connections or wires. improper connections or securing of wires may result in abnormal heat build up or fi re. • when wiring the power supply and connecting the wiring between the indoor and outdoor units, position the wires so. Piping connections liquid quantity 1 type flare connection od mm 6.35 gas quantity 1 type flare connection od mm 9.5 12.7 15.9 drain quantity 1 id mm od mm 18 piping length ou iu min. m 3 max. m 15 30 system chargel ess m10 additional refrigerant charge kg m 0.02 (for piping length exceeding 10m) level difference iu ou max. m. @mrengineerss @sntechnical #daikinsplitacwiring#splitacwiring#inverterac hello friends today i have put video about how to do wiring for daikin split ac ther.
Comments are closed.