Diy Knight Armor Cosplay How To Make A Foam Knight Armor Cost Here's a little video for those with short attention spans😁 i summed up my 30 minute knight armor tutorial video into 3 minutes! you can watch the full leng. Open up pieces 7 and 8 flat on a table with the smooth side up. there should be just a thin strip of the fabric visible along the seam between the two pieces. heat up that strip of fabric with the tip of your glue gun, applying just a little bit of glue at the same time. hold the piece down flat while the glue cools.
Diy Knight Armor Costume From Foam And Hot Glue Youtube 🤠get the pattern lostwaxoz shoppivoting rivet tutorial video watch?v= s0t3w61sio&list=plibqjq4h9zxekzdbw7 jx mssk952. Next, i cut out pieces of foam to fit into the gaps of the helmet. for the feather decoration on top, i cut out a ring shape from a piece of grey foam. then i cut a long narrow strip to wrap around the ring. lastly, i cut a feather shape from red foam and hot glued both the ring fixture and the feather onto the helmet. Glue the back two together along the long seam to create the backplate, and glue the strips along the bottom of the front piece. next, use a blowdryer or heat gun to form the foam. i added some curve to the sides of the backplate and the shoulders of both halves. for all the extra details of the foam knight armor i used thin eva foam the kind. Step 4: leg and foot armor. the manila folder patterns shown are my own as i could not find any to quickly reference. also i wanted a special look for mine. i literally formed the cardboard over my shin and sketched it to match the size and look i wanted.
Make Knight Armor From A Floormat And Hot Glue 35 Steps With Glue the back two together along the long seam to create the backplate, and glue the strips along the bottom of the front piece. next, use a blowdryer or heat gun to form the foam. i added some curve to the sides of the backplate and the shoulders of both halves. for all the extra details of the foam knight armor i used thin eva foam the kind. Step 4: leg and foot armor. the manila folder patterns shown are my own as i could not find any to quickly reference. also i wanted a special look for mine. i literally formed the cardboard over my shin and sketched it to match the size and look i wanted. Step 2: the helmet. this was arguably the most difficult part of the costume, as getting it right was key to the look of the costume. to start this off, i bought 3 sheets of creatology fun foam 12" x 16" (see pic) at michael's. this turned out to not be enough, so it was augmented with a club soda box. How to make an eva foam mat into an epic knight armor costume using simple crafting supplies like hot glue, a sharp knife and a bit of patience:).
Comments are closed.