Diy Transmission Flush Ford F150 Basically disconnect the return side of the transmission cooler line, start up the truck and empty out the pan. remove the pan, clean and replace filter. once back together, fill up the pan and start up the truck again. do this one more time or until you see the color of the new fluid. connect you cooler line back up and fill up the pan. 7. to flush the transmission, i used 5 8" inner diameter clear tubing (10 feet). i bought mine at my local home depot (~ $5). also, a 5 gallon bucket comes in handy to catch the used atf. 8. i unbolted the lines going into and out of the transmission cooler (behind the front bumper). the fittings were 7 8". 9.
Diy Transmission Flush Machine Lashell Hatch Thank you for watching!!!!!if this video was helpful to you and if you would like to place a donation, here is my venmo and paypal information. or i would re. In this video, i demonstrate a complete transmission fluid exchange on this 2016 ford f150 utilizing the transmission's oil cooler return line and a 5 gallon. Two people make this task easier. remove the drain plug and allow the tc to drain. it will take about 30 minutes to completely drain. finally, remove the 14, 10mm transmission pan bolts and lower the pan down. notice, little or no atf is in the pan. drop the filter into the pan and discard. 2004 2008 ford f150 diy transmission flush i have an 07 harley davidson edition with on 38,000 miles on it. i would like to replace transmission fluid with a higher end synthetic. i work on forklifts for a living so i have some mechanical aptitude and i am big on doing things myself. i have been reading and.
Comments are closed.