Engine Block Transformation After Chemical Dipping Youtube Today i’m i’m getting this old rusty chrysler 340 engine block down to bare metal. i’ll be taking all of you through the proprietary 3 step chemical dipping. When preparing new solutions or adding to existing ones, slowly sprinkle product over surface of solution. while stirring to avoid violent spattering. do not add large amounts of dry powder to solution at any one time. do not add to hot water or solution warmer than 43° to 49°c (110°f to 120°f).
Pontiac 428 Engine Block Transformation After A Chemical Dip About press copyright contact us creators advertise developers terms privacy policy & safety how works test new features nfl sunday ticket press copyright. Engine block transformation after chemical dipping. Done this with muriatic acid, but it was a desperate situation, a marine engine run with raw seawater cooling. after i treated it, the bock was found to be useless, the rust had masked many flaws, and they showed up in a pressure test. this acid should be handled very carefully; it is corrosive and the parts should be neutralized after treatment. Acid dipping is done to lighten up a part. if the block was dipped after machining, then there goes all the machine work. the acid has etched any or all the machining , making it useless for fitting anything , especially the pistons in the bore. it may have been dipped before the machining to remove any crud built up on the outside.
Chemical Dipping A Chrysler 340 Engine Block Youtube Done this with muriatic acid, but it was a desperate situation, a marine engine run with raw seawater cooling. after i treated it, the bock was found to be useless, the rust had masked many flaws, and they showed up in a pressure test. this acid should be handled very carefully; it is corrosive and the parts should be neutralized after treatment. Acid dipping is done to lighten up a part. if the block was dipped after machining, then there goes all the machine work. the acid has etched any or all the machining , making it useless for fitting anything , especially the pistons in the bore. it may have been dipped before the machining to remove any crud built up on the outside. Published: jul 25, 2011. the cleaning process should remove all of the dirt, grease, oil, rust, scale and carbon deposits that have accumulated over the years. with painted castings, the old paint also has to be stripped away so the surface can be repainted. even if you’re working with brand new castings, a final cleaning is still necessary. Acid dipping posted in problems, questions and technical: wasn't quite sure if this was the right section to ask in, but i'v just stripped an engine ready for re building it turbo style and was wondering if anybody could recommend anywhere to acid dip the engine block in the south east (se london preferably).
Comments are closed.