Framing A Exterior Wall Frame Interior Wall Step 2: measure and mark the plates. step 3: fasten the bottom plate. step 4: transfer the bottom plate location to the top plate location. step 5: install the studs. final thoughts. show 5 more. Determine which is the crown side. lay out your wall with all of the crowns pointed up. cut the studs to length with a circular saw or hand saw. lay the bottom plate and the first stud on edge and nail them together with 16d nails. complete the new interior wall frame by nailing the wood studs to the sole plate.
Basic Wall Framing Jlc Online Framing Walls Walls And Ceilings Before you begin framing your corner, gather the following materials: 2x4s or 2x6s (depending on your wall thickness) 16d common nails. 8d common nails or 3 inch construction screws. drywall clips (for interior corners using the two stud method) rigid insulation or spray foam (for exterior corners) scrap lumber (if using as backing instead of. Plumb with a long level. using a plate level, plumb the corners starting with the longest wall. once the wall is plumb, fully nail the end of the wall to the intersecting wall that forms the corner. plumb all the corners on the exterior walls of each floor, and fully nail them before straightening anything. Mark identical spots on each board at 16 inch intervals. hold the studs in place one at a time and nail them into place through the top plate. (if any studs are warped, turn them so that the imperfect end is at the bottom.) repeat with the bottom plate, ensuring the edges of the studs are flush with the edges of the plate. With the openings marked, lay out the stud locations. the goal is to position the studs every 16 or 24 in. so that the edges of 4×8 sheets of plywood align with the centers of studs. subtract 3 4 in. from the first layout mark. then hook your tape on a partially driven nail at this mark, and mark at each 16 or 24 in. multiple.
Comments are closed.