#fursuit making problems . rood hyena 02 28 19 . 135. 5. i only had small scraps of fur left over to work with. A: arrows indicate fur direction! once a foam base is finished, i cover it with duct tape or masking tape, draw the patterns on, then mark which way the fur goes. (fur generally goes away from the nose, eyes, bottom lip, then down the chin and head, and up to the tips of the ears! fur direction is very important when making a head, if it’s.
Your completed fursuit base. the fur entirely sewn and ready to be put on the base (not glued down yet) needle and thread sewing machine. your fabric of choice for the lining. paper scrap for patterns. duct tape or painter's tape. hot glue gun and glue. flexible measuring tape. first, you'll need your foam headbase and the fur entirely sewn. We’re all here to learn! (community is sfw, keep it within reason!) some safety tips for newer makers: whenever you’re shaving fur, wear a bandana mask, something to cover your nose and mouth. if you don’t, you may get something called groomers lung. it’s not fun, trust me. whenever you’re shaving fur (again), never have any pets in. Also there are a lot of cheaper fursuit makers who make and sell fursuits for under $500. depending on budget a good place to look would be fursuit maker amino, there's lots of suit makers on there who have more affordable fursuits. Hot water will damage the fake fur! and please never put any fursuit part in a dryer you could permanently damage the fur, all parts should be left to air dry and occasionally brush the fur in the right direction while drying. you can try to use a fan to speed up the drying.
Comments are closed.