Good Idea Make Cement Flower Pot With Cardboard Mold Making cement flower pots can be a fun and creative project. here's a simple guide to get you started:materials needed:cement mixwaterlarge container (to mix. Good idea make cement flower pot with cardboard mold.
Cement Good Idea Make Flower Pots With Styrofoam And Cement Simp Great! tips make cement flower pots with cardboard molds easy & beautifulhow to make cement pots from carton boxes and ceramic tilesflower pots craft, diy. Mix a batch of quick setting concrete, according to the directions on the package. add concrete color at this point, if desired. 5. pour 2 inches (5.1 cm) of the concrete mixture into the larger container. poke the pieces of pipe into the concrete, with 3 to 4 inches (7.6 to 10.2 cm) between each pipe. Remove the screws from the form and the dowel. gently peel away the sides, as shown, and tilt the planter onto its side. use your drill driver and a ¼ inch bit to loosen the drain dowel, and a hammer and chisel to punch it out. we finished our planter with a water based translucent concrete stain from quikrete. Wipe the inner and outer molds with motor oil or release spray. make sure to get crevices or corners well. place the molds on a level surface. fill the mold. fill the bottom of the outer planter to the depth of the bottom of the inner mold. place your mold inside and fill around the sides evenly with concrete mix.
Make Cement Flower Pot With Cardboard Mold Cement Craft Id Remove the screws from the form and the dowel. gently peel away the sides, as shown, and tilt the planter onto its side. use your drill driver and a ¼ inch bit to loosen the drain dowel, and a hammer and chisel to punch it out. we finished our planter with a water based translucent concrete stain from quikrete. Wipe the inner and outer molds with motor oil or release spray. make sure to get crevices or corners well. place the molds on a level surface. fill the mold. fill the bottom of the outer planter to the depth of the bottom of the inner mold. place your mold inside and fill around the sides evenly with concrete mix. To make the drainage hole for the concrete planter, take a piece of a drinking straw that's about ¼” high and use hot glue to glue to the bottom of the container. use hot glue to also fill in the top open end of the straw. mix the concrete to a thick milkshake consistency and then pour the concrete into the mold. 1. mix concrete and water in a wheelbarrow or bucket. [6] read all of the instructions on the package of concrete so you know the ratio of concrete to water. put on a pair of gloves and pour the concrete mix into the wheelbarrow or bucket. then, slowly pour in the appropriate amount of water into the concrete mix.
Comments are closed.