The Complete Guide To Installing Hardie Board Siding Expert Tips Find installation instructions and technical docs for james hardie products, the leading brand of fiber cement siding and trim. Install it with 6 inches of clearance at the bottom. this strip should be 1.25 inches wide. install it by driving nails into place near the top edge, and make sure the board is at a slight angle.
James Hardie Installation Guide Northville Lumbernorthville Lumber Hardie® plank lap siding requires a starter strip beneath the first course. you have two options here – you can make your own or you may be able to find acceptable prefabricated, third party starter strips available for purchase. you can make your own fiber cement starter strip by ripping a piece of hardie® plank lap siding into 1 1 4 inch. Using the screw pattern as a guide, fasten your hardie® backer cement board with nails or screws every 8” on center over the entire surface. keep screws between ⅜” and ¾” from board edges and 2” from board corners. set your screwheads flush with the surface. be careful not to overdrive them. fill all the joints with the same mortar. Before installation, confirm you are using the correct hardiezone® product instructions by visiting hardiezone or call 1 866 942 7343 (866 9 hardie) storage & handling: store flat and keep dry and covered prior to installation. installing siding wet or saturated may result in shrinkage at butt joints. First, sheath the walls with foam, plywood, or oriented strand board (osb). next, cover the sheathing with felt paper or house wrap. after that, mark the locations of the studs with chalk lines. cut the siding – using a circular saw is the most popular method for cutting siding. however, it also produces the most dust.
Hardieplank Lap Siding Installation Instructions Before installation, confirm you are using the correct hardiezone® product instructions by visiting hardiezone or call 1 866 942 7343 (866 9 hardie) storage & handling: store flat and keep dry and covered prior to installation. installing siding wet or saturated may result in shrinkage at butt joints. First, sheath the walls with foam, plywood, or oriented strand board (osb). next, cover the sheathing with felt paper or house wrap. after that, mark the locations of the studs with chalk lines. cut the siding – using a circular saw is the most popular method for cutting siding. however, it also produces the most dust. This strip will tip the first piece of siding to the proper angle. measure and cut the first piece of siding to length and nail it in place. leave a 1 8 inch gap where the end meets the corner board, and make sure the other end lands on a stud line. install the next piece so its end butts lightly against the first. 1. start installing your boards a quarter inch above the floor, tub, or shower board and caulk accordingly. 2. fasten cement board with specified nails or screws, a maximum of 8” on center at all supports. 3. keep fasteners ⅜” from board edges and 2” in from sheet corners. 4.
Comments are closed.