The cooling system cools the engine as well as stabilizes the temperature to meet the engine’s operating requirements. the main function of the engine cooling system is to maintain the engine temperature as normal and prevent it from overheating. the engine cooling system cools the engine by circulating coolant through the engine vents. In order for the system to work, the coolant needs to move throughout the system. the water pump uses power from the crankshaft and serpentine belt to force coolant into the engine and through the rest of the cooling system. allow your engine to run for a few minutes before inspecting your water pump. visually check for leaks around the unit.
1] removes extra heat: it is the main function of the engine cooling system to carry away the excess heat generated by the engine. 2] helps to attain optimum temperature faster: the optimum temperature means the temperature at which the engine gives better performance. thus, after starting the engine, it is necessary that the engine should. 1. radiator. the radiator is responsible for cooling the engine coolant. it is typically located at the front of the vehicle, behind the grille. the radiator contains a series of tubes and fins that help dissipate heat from the coolant as air flows through it. this process cools the hot coolant before it is circulated back to the engine. When the engine warms up, the wax melts, expands and pushes the valve open, allowing coolant to flow through the radiator. when the engine stops and cools, the valve closes again. water expands when it freezes, and if the water in an engine freezes it can burst the block or radiator. so antifreeze usually ethylene glycol is added to the water. Learn the basics of engine cooling system with 3d animation and clear explanations. a must watch for car enthusiasts and curious minds.
Comments are closed.