Use a flat screwdriver to push straight out 1 4 inch as coolant will start dripping. remove the coolant bleed screw on the hose near brake fluid reservoir. open the cap on the coolant reservoir too. put a catch basket underneath. slide the clamp off and disconnect the rear hose to the oil cooler. About press copyright contact us creators advertise developers terms privacy policy & safety how works test new features nfl sunday ticket press copyright.
Loosen the spring clamp and push it out of the way, towards dash. pull pipe until it nearly comes off. when right at the end of the heater pipe, the air should escape. why audi use this very basic setup, i don't know. the rest of the system is self bled, but the engine can be revved or driven to get rid of the air in the engine coolant. Ea288 can be many different engines and cooling system layout, different pumps etc! information from erwin is needed and right equipment, vas 6096 just a few engines: clha, crbc, crka, crkb, crlb, crua, cvca, cuna, cusa, cusb, cuta, cuaa. we have not seen an autoscan from your a5. 1) ignition on engine off. Drain coolant. 1. jack front end of car up enough to fit a bucket under the car, on the left side of the radiator core. 2. place bucket under the lower radiator hose at the core. 3. remove reservoir cap. 4. (3.0l only) locate drain cock on lower radiator hose, near the core: 5. How to bleeder air for the coolant system audi model.
Comments are closed.