How To Change Spark Plugs On A Ford Explorer 4 0 Sohc Engine Youtube In this video, i will show you a quick overview of how to change out the spark plugs on a 1999 ford explorer 4.0l sohc vin e engine. Recently changed my plugs and wires on a 97 4.0 sohc. didnt take any wheels off just used extension bars with the end that allows some movement to the socket.not easy but not impossibie.one thing i did do was push the plugs into a piece of tubing ( wire end first) then start screwing them into the engine by hand as they grip the rubber pulls off and then they just need tightening up.
Change Spark Plugs 1996 Ford Aerostar Van This video will show you how to change the spark plugs and spark plug wires in a 2006 2010 ford explorer with a 4.0 engine.this is a fairly easy to perform m. The actual engine "firing order" is 1 4 2 5 3 6 for the 4.0l v 6 engine. prior to installing the new spark plugs, double check the gap setting which is .061 to .068 for the 4.0l v 6's, 2005 and earlier models. once you have your new plugs partially threaded by hand and ready to torque them up, do not over tighten them. Don't be scared, it's super easy. step one, pull passenger wheel and inner fender plastics. step two, remove, they are right there and don't get any easier. driver side you can get from the top. click to expand the obstructions (heater radiator, etc.) on my 2003 4.0 sohc are much lower than that pictured. Spark plug replacement ford explorer 4.0l 2001 tips install remove replace how to change. should be good for the mercury mountaineer as well2020 has really.
2000 Ford Explorer Spark Plug Firing Order Wiring And Printable Don't be scared, it's super easy. step one, pull passenger wheel and inner fender plastics. step two, remove, they are right there and don't get any easier. driver side you can get from the top. click to expand the obstructions (heater radiator, etc.) on my 2003 4.0 sohc are much lower than that pictured. Spark plug replacement ford explorer 4.0l 2001 tips install remove replace how to change. should be good for the mercury mountaineer as well2020 has really. Choose any spark plug wire and remove it from the cylinder head by pulling and twisting it out of the hole. remove the spark plug from the engine using the ratchet, extension and spark plug socket. discard the old plug. use the spark plug gapping tool to gap the replacement spark plug to .054 thousandths of an inch. Thanks for the tutorial. i struggled for hours to replace the plugs on the passenger side of my 1999 4.0l sohc. there is literally no way to get to it from above if your hands are anywhere near adult size. i finally resorted to searching here and found your instructions. once i pulled off the right, front wheel and splash guard, it became much.