How To Check The Solenoid On A Riding Lawn Mower Hunker Step 4. bridge the gap between the posts with your insulated screwdriver. if the starter spins when you make contact, the solenoid is bad; if the starter does not spin, the starter is bad. the starter solenoid on a riding lawn mower is essentially an electromagnetic switch. this switch closes when you turn the ignition key, allowing electricity. Step by step!today i'll be showing you how to test a starter solenoid on a riding lawn mower!follow the steps in this video & you'll be back to cutting grass.
How To Check The Solenoid On A Riding Lawn Mower Hunker First, i always like to remove the starter battery from the lawn mower and have it on my workbench. this makes testing the solenoid much easier. so, grab a socket wrench and remove the terminals from the lawn mower’s battery. then, remove the support brackets from the battery and lift the battery off of the lawn mower. Step 4. check the output, which should always be at least 30 volts. your owner's manual will have the exact required output of your stator. if the tested output is lower than 30 volts, the stator usually needs to be replaced. the stator on a riding mower is located on top of the engine below the flywheel. as the flywheel turns over the top of. Make sure your lawn mower is in neutral. turn the key to the on position. 3. bypass the starter solenoid using a screwdriver. lay a long screwdriver over the solenoid to touch the two cables to bypass the starter. the two cables you are looking for are the cable from the battery and cable to the starter. How to test a starter on a riding lawn mower.
Comments are closed.