How To Check Transmission Fluid On Automatic Transmissions Haiper Step 2: prepare to check the fluid. consult the owner's manual to confirm whether the transmission needs to be warm or cold before checking the fluid. put the vehicle in park gear on a level. Recheck the dipstick level. with the dipstick wiped clean, put it back in the tube. pull the dipstick back out and check how full the system is. you want the transmission fluid line to hit the full mark on the dipstick. if it needs more, add the appropriate automatic transmission fluid, but don’t overfill it.
How To Check Your Automatic Transmission Fluid Haiper Step 2: add fluid through a funnel. you can add more by inserting a funnel into the tube the dipstick was withdrawn from and pouring a small amount of automatic transmission fluid into the pipe. check the level each time you add a little until the level is right between the two lines. note: add fluid while the engine is running in the proper. With the engine at idle, raise the vehicle on a hoist or lift using a jack supported by jack stands. the vehicle must be level with transmission in park. remove the dipstick plug with the level indicator attached. the image below has the fluid pan removed so you can see the level indicator. unscrew the plug and proceed to check the fluid level. Checking the fluid level. let the engine run for two minutes with the selector at park 'p'. the transmission fluid level is best checked when the engine is at normal running temperature. after a 5 mile run, park on level ground and apply the handbrake . with the engine idling, move the gear selector lever at least three times through all positions. Check transmission fluid without a dipstick.
Comments are closed.