How To Connect 4 Conductor Speaker Wire 3 Methods First, twist the two positive wires together (red and white wires). connect the combined wires to the terminal. then, twist the negative wires together (black and green). connect those two wires to the – terminal. important: the 1st and 2nd methods are excellent for speakers and amps with two terminals. However, wiring 4 terminal speakers can be complicated when you’re a beginner with wiring. in general, you can wire your 4 terminal speakers in three different ways: bi wiring. bi amping. leave the conductive bar between its terminals and connect the speaker wires. in this article, learn how to wire speakers with 4 terminals in various ways.
How To Connect 4 Conductor Speaker Wire 3 Methods Connect the other end of the speaker wire to your speakers. the same method will apply here. remove the bridge plates or pins from the bi wiring posts and then insert the wire for each (making sure to check that the correct wires are running to the bass and treble posts and that the polarities of the wires are correct). tighten the posts. This is bi wiring. banana plugs one on each conductor at speaker end, two conductors connected to each banana at amplifier end. make sure the plugs are big enough for both conductors. make sure you have enough plugs to go round (4 on amp 4 on mks 8 on kefs) = 16. First, strip the outer covering of the speaker wire to expose the 4 inner conductors. strip 2 inches of the covering on red and black conductors. twist the copper strands of the red conductor together and do the same with the black conductor. now take the two stripped ends and insert them into the spring clip terminals of the receiver. 2. cut the proper length of speaker wire to run between your speakers and the audio source. 3. split one end of the speaker wire. this will leave you with two bare ends of wire rather than one. 4. match each end of the split wire with the positive and negative terminal on one set of the speaker terminals. 5.
How To Connect 4 Conductor Speaker Wire 3 Methods First, strip the outer covering of the speaker wire to expose the 4 inner conductors. strip 2 inches of the covering on red and black conductors. twist the copper strands of the red conductor together and do the same with the black conductor. now take the two stripped ends and insert them into the spring clip terminals of the receiver. 2. cut the proper length of speaker wire to run between your speakers and the audio source. 3. split one end of the speaker wire. this will leave you with two bare ends of wire rather than one. 4. match each end of the split wire with the positive and negative terminal on one set of the speaker terminals. 5. Ensure the entire speaker system is powered off. remove the speaker’s bi wire bridges. connect each of the amp channels to the respective speaker section. find the bi amping terminals at the receiver’s back. set the desired level of control on your amps (set the same levels of control if the amps are identical). Here’s how: loosen the binding post twist tops enough to expose the wire hole. strip the speaker wire to about 3 8″ to 1 2″ length bare wire. twist the wire tightly by hand to keep the wire strands together. insert the wires into each speaker terminal one at a time up to (but not including) the insulation.
Comments are closed.