Single out the hair on the top of your head. run the clippers without attachment bottom to top and stop once you get to the lower fade line. using the guard size between #3 and #4, trim the fade area moving the clippers sideward. with a smaller guard size, blend out the bottom section of the fade. Holding your sheers vertically, cut into the corners to remove bulk. 4. taper your neckline. use your clippers or a beard trimmer to cut the hair growing on the nape of your neck. start with a grazing cut at the top of the neckline, then cut progressively closer as you work toward the nape of the neck.
Using a comb, bristles facing up, lift the hair on the lower half of the head and begin to cut (¼ inch in length) from the base of your head. repeat, going a little bit higher but not into the transition zone. move upward 1 4 of an inch at a time – the smoother movements usually result in a cleaner look. Line up the sides of the hair by using your clippers to cut the hair up and off of his ears. turn the clippers on their side and use the edge of the blade to cut the hair from back to front, going against the grain. [7] tilt the clippers at a 45 degree angle so the hair blends and fades better. part 3. Learn how to give yourself a quick & easy self haircut without any barbering experience— with this self haircut strategy, you can easily get multiple hairsty. She says to do it once a week. “if the sides still feel a little bulky with your level 2 on the top, use your 1.5 on the sides, first with the clipper lever open.”. this generates slightly.
Learn how to give yourself a quick & easy self haircut without any barbering experience— with this self haircut strategy, you can easily get multiple hairsty. She says to do it once a week. “if the sides still feel a little bulky with your level 2 on the top, use your 1.5 on the sides, first with the clipper lever open.”. this generates slightly. Step 3: trim the back. i go bottom to top in an against the grain motion once more. usually this is where you’ll need a small hand mirror to see how your cutting efforts are turning out. yes, you can get by just “feeling” the length of your hair. however, there’s a high chance you’ll miss some parts. Step 6) trim the top of your head. once you're done with the sides and back, you'll want to trim the top of your head. the way in which you do this will depend on how much length you want on top. if you're going for an all over length, just use the same clipper attachment as you did for the sides.
Comments are closed.