Auto trans plastic cooling line quick connect removal when you have limited room no special tools required or when the line removal sleeve tool won`t fit can. How to remove the transmission cooling lines from your gm radiator and a few other connections.
Learn how to replace (or just remove the lines from) the transmission cooler lines quick disconnects on the left (driver’s) side of the radiator. even with t. June 13, 2013. #1. ford manual indicates there is a special "quick disconnect tool" required to disconnect the transmission cooler lines from the radiator in order to remove the radiator. i purchased a set of 4 "quick disconnect" tools from the auto parts store last year. one of those was for use on my fuel rails' "quick disconnect" connections. I want to flush my transmission before doing a full service, and read stickies on removing the trans line from the radiator, inserting a 3 8" barbed fitting and hose, and idling and pumping the fluid into a bucket, using a extension pipe. i have done this procedure on other cars, but i see there is this black ring around transmission line just. Disconnect both transmission cooler lines at the cooler. hang them into a 5 gallon empty buck. get under the car and remove transmission fill hole. get 10 quarts or so of new atf and start up the car. now, simply pump in the new fluid into the transmission at the same rate the old is flowing out of the cooler lines.
I want to flush my transmission before doing a full service, and read stickies on removing the trans line from the radiator, inserting a 3 8" barbed fitting and hose, and idling and pumping the fluid into a bucket, using a extension pipe. i have done this procedure on other cars, but i see there is this black ring around transmission line just. Disconnect both transmission cooler lines at the cooler. hang them into a 5 gallon empty buck. get under the car and remove transmission fill hole. get 10 quarts or so of new atf and start up the car. now, simply pump in the new fluid into the transmission at the same rate the old is flowing out of the cooler lines. Step 3: prep the new line or plug. step 4: install the new line or plug. step 5: reinstall the line to the radiator. step 6: reinstall underbody panels and splash shield. following these steps will help you effectively plug your transmission cooler lines on the radiator, ensuring a smooth and efficient transmission system. The automatic transmission lines on a 2005 and 2006 are a funky quick connect system. no after market radiator supplied them and i could not find a solution. i was about to rig something up. i found the above thread. on the very last page is had the dorman oe solutions transmission cooler line for a gm. see link below.
Comments are closed.