Buy Vevor Hydraulic Power Unit 12 Volt Dump Trailer Hydraulic Pump On this video, i will show you guys how to install a 12v double acting hydraulic pump to a dump tilt roll off trailer. pretty simple. here is the 6 quick ste. Wiring up or connecting a 12 volt dc electric hydraulic pump or power pack is not too complicated if you have the right instructions, tools, cables, and conn.
Buy Vevor Hydraulic Power Unit 12 Volt Dump Trailer Hydraulic Pump Mount the power unit using two, 3 8 16 x 3 4 mounting bolts (diagram a 3). connect hydraulic lines to ports “a” top & “b” bottom (diagram a 4).a. connect the “a” port hose to the base of the cylinder.b. connect the “b” port hose to the rod end of the cylinder. remove the filler breather cap and fill the reservoir with hydraulic. If you need help or advice about how to wire flowfit's double acting & single acting power units, then please watch our video. Connect the positive cable from the battery to the start solenoid (diagram a 5). (please see battery cable gauge table for proper gauge for your length of cables.) use a wrench to hold the bottom nut in place, to torque the upper nut (to 3 ft. lbs.) to fasten the battery connections. reconnect the two button remote pendant at the quick disconnect. Vevor hydraulic pump installation instructions: working principle and wiring method. 1. please fill in hydraulic oil from o13 reservoir filler till it is 3cm to 5mm below the upper surface of the reservoir; the positive pole of the power supply should be connected to the positive pole of the relay while the negative pole of the power supply.
Buy Vevor Hydraulic Power Unit 12 Volt Dump Trailer Hydraulic Pump Connect the positive cable from the battery to the start solenoid (diagram a 5). (please see battery cable gauge table for proper gauge for your length of cables.) use a wrench to hold the bottom nut in place, to torque the upper nut (to 3 ft. lbs.) to fasten the battery connections. reconnect the two button remote pendant at the quick disconnect. Vevor hydraulic pump installation instructions: working principle and wiring method. 1. please fill in hydraulic oil from o13 reservoir filler till it is 3cm to 5mm below the upper surface of the reservoir; the positive pole of the power supply should be connected to the positive pole of the relay while the negative pole of the power supply. 1. install 9 16 18 sae orb, sae #6, hydraulic fitting into “p” port. torque to 18 ft lbs. 2. remove the two button pendant from the power unit at the quick disconnect. 3. mount the power unit using two, 3 8 16 unc mounting bolts (diagram a 2) 4. with the cylinder full retracted, remove the filler breather cap and fill the reservoir with. Mount the power unit using two, 3 8 16 x 3 4 mounting bolts (diagram a 3). connect hydraulic lines to ports “a” top & “b” bottom (diagram a 4). connect the “a” port hose to the base of the cylinder. connect the “b” port hose to the rod end of the cylinder. remove the filler breather cap and fill the reservoir with hydraulic.
Comments are closed.