How To Install And Remove The Collar Bearing In this video, shane has a few quick tips on how to properly change a lock collar. in this video, shane has a few quick tips on how to properly change a lock collar. After putting the collar on the shaft, use a hammer and drift to make sure the collar is tight (hand tight is not enough!)install and hit in the direction th.
Mounted Bearing Locking Collar Which Is Best Baart Group Take home points:1. turn locking collar in direction of shaft rotation2. tap in direction of rotation 2 3 times with punch and hammer3. use anti seize compou. Slip the bearing on the shaft and then put the lock on and barely tighten it by hand, the way you're doing it. now hold the collar and turn the shaft and inner race like the bearing was starting to sieze. if you've tightened opposite the rotation, the collar will loosen. if you've tightened with the rotation, the collar will get tighter if the. Snug the collar on the mating eccentric in the direction of shaft rotation. place a mild steel bar inside the hole provided by the collar and tap the collar sharply in the direction of shaft rotation and perpendicular to the shaft. tighten the setscrew in the collar to the proper torque (from our mounted ball bearing installation manual ). Install the outer flange but only snug the nuts or bolts securing it for the time being. slip the new collar over the shaft with the recessed face toward the bearing. gently push and rotate the collar unit it seats over the eccentric inner race of the bearing. continue to rotate the collar in the same direction as normal rotation of the shaft until.
How To Install And Remove The Collar Bearing Snug the collar on the mating eccentric in the direction of shaft rotation. place a mild steel bar inside the hole provided by the collar and tap the collar sharply in the direction of shaft rotation and perpendicular to the shaft. tighten the setscrew in the collar to the proper torque (from our mounted ball bearing installation manual ). Install the outer flange but only snug the nuts or bolts securing it for the time being. slip the new collar over the shaft with the recessed face toward the bearing. gently push and rotate the collar unit it seats over the eccentric inner race of the bearing. continue to rotate the collar in the same direction as normal rotation of the shaft until. I recently rebuilt worthington the drive on my sheldon mw 56 p lathe. the top jackshaft assembly uses 2, 7 8" pillow block bearings with eccentric locking collars. the standard installation procedure for this type of locking collar calls for turning the eccentric on the bearing flange in the direction of shaft rotation until it binds. Place the eccentric locking collar on the shaft with its cam adjacent to the cam on the end of the bearing inner ring. the eccentric collar’s recessed cam will engage the corresponding cam on the bearing inner ring. turn the collar in the direction of shaft rotation. 4. rotate the shaft by hand while tightening the mounting bolts.
Comments are closed.