How To Install A Bottle Trap With Pop Up Drain Stopper To Replace Your Items i used: bottle trap w pop up drain plug (flat black) amzn.to 3b1dwzj bottle trap w pop up drain plug (silver) amzn.to 2ubwmmg b. Chris shows in this quick video a step by step instruction of how to install a pop up drain assembly in a bathroom sink. the standard gaskets are replaced w.
How To Install Or Replace A Universal Telescopic Bottle Trap For A Items i used on this video: pop up drain stopper with built in anti clogging strainer amzn.to 3dr3on7 oatey plumbers putty amzn.to 3xuc. Step 5: secure the assembly. before proceeding with the pop up drain installation, position the drain body so the socket for the pivot rod faces the back of the sink. tighten the slip joint nut on the drain body to compress the gasket and seal the drain body to the flange. this will also tighten the flange against the sink. Undo the screw that connects the extension bar and the lift rod. lift out the pop up drain stopper with your fingers or a flathead screwdriver. disconnect the p trap and remove the sink stopper's drain pipe. take each piece to the hardware store and find replacements. reassemble the sink drain pipe and the new stopper. The pivot rod installation steps are: slide the pivot nut over the rod as shown below. insert the rod at a slight downward angle to catch the pop up stopper. when the rod engages the pop up stopper, you’ll see the stopper bob up and down in the sink bowl. give the pop up stopper a tug to verify it has captured the end of the pivot rod.
How To Replace A Pop Up Stopper With Sinkstrain Stopper By Pf Undo the screw that connects the extension bar and the lift rod. lift out the pop up drain stopper with your fingers or a flathead screwdriver. disconnect the p trap and remove the sink stopper's drain pipe. take each piece to the hardware store and find replacements. reassemble the sink drain pipe and the new stopper. The pivot rod installation steps are: slide the pivot nut over the rod as shown below. insert the rod at a slight downward angle to catch the pop up stopper. when the rod engages the pop up stopper, you’ll see the stopper bob up and down in the sink bowl. give the pop up stopper a tug to verify it has captured the end of the pivot rod. Install the stopper – place the stopper into the drain from the top and ensure the hole is facing the back of the sink. returning to the bottom, take the nut with the ball on the inside and thread it into the drain pipe. go ahead and push the rod to make sure the drain is moving up and down. if it works correctly, tighten the nut. Put the drain stopper into place. insert the pop up stopper into the drain opening inside the sink, ensuring the linkage hole faces toward the sink's back. from under the sink, insert the pivot rod into the opening in the side of the tailpiece. usually, there is a plastic washer on each side of the plastic ball.
Comments are closed.