How To Install A Car Stereo Fast Car How to install car head unit an aftermarket car media center (double din) | (made easy with all the steps). this is how you install an aftermarket car head. Disconnect the ground cable from your car battery before beginning. remove the dashboard and remove the factory stereo. connect the new wiring harness adapter to your car, and then connect the stereo. replace it into the dashboard, and then test it before reassembling the dashboard. part 1.
Car Stereo Head Unit Installation Using a soldering iron or a soldering torch, heat the wire and feed in your solder slowly until it absorbs into the wire. let cool and test the solder job by tugging on the two wires. after the wires cool, move your shrink wrap back over the soldered area. if you didn't use shrink wrap, apply electrical tape. Stay super up to date with our latest version of "how to change your head unit" by clicking the link down below: youtu.be yzyooemmcyqfor full up to da. Insert the din tools into the holes on either side of the unit until you hear a click. the tools serve to release the spring clips and also hook onto the sides of the stereo so that you can pull it out easily. spread the tools apart slightly then pull the stereo out of the dash. Third, prepare the aftermarket stereo by properly mounting the unit in the dash kit by following the instructions that are included. next, use butt connectors to connect the stereo’s wiring harness to the vehicle wiring harness adapter. step 4: install additional stereo accessories.
Comments are closed.