How to install a dual xdvd236bt double din car stereo from start to finish for beginners.hello everyone crimped connections are preferred method used by most. Insert the din tools into the holes on either side of the unit until you hear a click. the tools serve to release the spring clips and also hook onto the sides of the stereo so that you can pull it out easily. spread the tools apart slightly then pull the stereo out of the dash.
Sand down the area with sand paper to ensure a good connection. 5. connect the remaining wires. plug in the antenna cable and connect the stereo's wiring adapter to the the car's wire harness. connect the output converter if one is needed to make the new stereo compatible with the car's audio system. Looking for a stereo or accessories for your vehicle? use our auto fit guide to find everything for your car. sonicelectronix afg?utm source=yo. Disconnect the ground cable from your car battery before beginning. remove the dashboard and remove the factory stereo. connect the new wiring harness adapter to your car, and then connect the stereo. replace it into the dashboard, and then test it before reassembling the dashboard. part 1. Pulling out the old stereo. after pulling the stereo unit forward, you should see it is wired inside the dashboard. there should be at least one connector, or wiring harness, among the bunch of wires, sometimes called a pigtail. grab both sides of the connector and pull it to detach the wiring.
Disconnect the ground cable from your car battery before beginning. remove the dashboard and remove the factory stereo. connect the new wiring harness adapter to your car, and then connect the stereo. replace it into the dashboard, and then test it before reassembling the dashboard. part 1. Pulling out the old stereo. after pulling the stereo unit forward, you should see it is wired inside the dashboard. there should be at least one connector, or wiring harness, among the bunch of wires, sometimes called a pigtail. grab both sides of the connector and pull it to detach the wiring. When you get your hands on a new stereo for your ride, you can either install it yourself to save money or spend $200 800 hiring a professional to do it for you. installing a car stereo can be tricky. checking your ride’s wiring diagrams and the new stereo’s installation instructions will help. hiring a professional ensures a fast and. If your car stereo has an aux (auxiliary) input, you can connect your phone using a 3.5mm audio cable. plug one end into the headphone jack of your phone and the other into the aux input on your car stereo. select the aux input source on your car stereo to hear the phone’s audio. usb connection.
Comments are closed.