Measure the floor. you’ll need to accurately measure the floor area so you can buy the right amount of vinyl plank flooring. add between 10 and 20 per cent for wastage. 3. prepare the subfloor. remove any old flooring and make sure the subfloor is rigid, level and there are no cracks. How to install vinyl plank flooring as a beginner!see my flooring install playlist: bit.ly 2ufkwp6🎥 watch next:10 beginner mistakes installing vinyl.
Pick the longest wall and start there. use your spacers against the wall to maintain that essential expansion gap. lay your first plank down, then continue along the wall, clicking each new plank into the previous one. check with a level to ensure this row is straight because it’ll guide the rest of your installation. Need answers or advice for your diy project?become a diy member now! click 👇🏼 c homerenovisiondiy membership get full access to me. Lay the first plank appropriately spaced from the wall. install the second plank by holding it at an angle and inserting its tongue edge into the first plank’s groove edge. lower the second plank to snap the planks together. continue in this manner for the remainder of the row, trimming the last plank as needed. Diving into vinyl plank flooring installation. 1. begin the installation: jump into the installation by placing the first plank along the reference line in a corner, ensuring a 1 4 inch gap from the wall for expansion. use position spacers to sustain this gap throughout the process. 2.
Lay the first plank appropriately spaced from the wall. install the second plank by holding it at an angle and inserting its tongue edge into the first plank’s groove edge. lower the second plank to snap the planks together. continue in this manner for the remainder of the row, trimming the last plank as needed. Diving into vinyl plank flooring installation. 1. begin the installation: jump into the installation by placing the first plank along the reference line in a corner, ensuring a 1 4 inch gap from the wall for expansion. use position spacers to sustain this gap throughout the process. 2. Step 4: prepare the first few rows of flooring. for the first row, use a full plank. for the second row, cut one third off the plank with the flooring cutter or miter saw. for the third row, remove two thirds. repeat this process for the first piece in each row as you move across the room, staggering the joints and creating a more appealing. Lay the underlayment from wall to wall, taking care not to overlap the seams. instead, tape the seams together with underlayment or housewrap tape. step 3: start the first course. starting on one.
Comments are closed.