How To Make A Telescoping Antenna Mast Shapovmusic It goes from 10' to about 22'. view attachment 160643. instead of bolting mast sections together you can buy the actual mast clamp used on push up masts for about $6. here is how i made some push up masts. but the op is looking for a way to attach a cable and winch so it can crank up. General steps for building a 40′ mast. 1. preparation. make sure to choose a spot that’s far away from any overhead power lines. once you’ve chosen an appropriate location, dig a hole in the ground that’s at least 4 feet deep and 2 3 feet wide to prepare the area for the antenna base.
60 Foot Telescoping Antenna Mast In making this telescoping mast i thought i should use it for a vertical we are always looking for a simpler way to swing a beam into the air on field day. John draper’s 40’ diy antenna mast. our first stop is at savenetradio, where john draper lays down his plan for a 40’ diy mast. his plan is simple, dig a hole for your base, pour in some concrete, and reinforce it with some steel tubes. finally, install your 40’ aluminum antenna mast. as i said, simple and also clear. I am installing a 33 foot telescoping antenna mast. the two antennas that will be mounted are the comet gp3 dual band, (2 meter 70 cm) and the alpha delta. Step 2: install the antenna mast mount. the next step is to install the antenna mount. this is the bracket that will hold the mast in place. next attached lowered mast to the base. the mount should be attached to a solid surface like a wall or a chimney. see also how to improve motorcycle radio reception. make sure to use the proper hardware.
Comments are closed.