How To Make Cement Pot At Home Make Flower Pot Youtube To make the drainage hole for the concrete planter, take a piece of a drinking straw that's about ¼” high and use hot glue to glue to the bottom of the container. use hot glue to also fill in the top open end of the straw. mix the concrete to a thick milkshake consistency and then pour the concrete into the mold. In this diy video, i'll show you how to make a large concrete planter using 2 buckets and a bag of concrete. making your own large round concrete flower pot.
How To Make Cement Flower Pot At Home Cement Flowerpot Youtube Step 3: fill pre made silicone molds. filling pre made molds is easy. molds come with two pieces, a soft silicone form and a harder plastic form. place the soft mold into the hard plastic form and simply fill with concrete (image 1). use a knife or skewer to stir the concrete once it is in the mold. Don your latex gloves and start mixing cement in your 5 gallon bucket. follow the instructions on your bag of cement to get the right ratio. start by mixing equal parts cement mix and water. if it looks dry, add more water. add more cement mix if it looks especially wet. Press the inner mold into the concrete. push the inner mold down into the center of the concrete. make sure to set the inner mold down far enough to create adequate depth for plants' roots, but also leave about an inch thickness for the bottom of the planter. brie goldman. Mix a batch of quick setting concrete, according to the directions on the package. add concrete color at this point, if desired. 5. pour 2 inches (5.1 cm) of the concrete mixture into the larger container. poke the pieces of pipe into the concrete, with 3 to 4 inches (7.6 to 10.2 cm) between each pipe.
How To Make Cement Pot Learn To Make Pot With Cement Easy Technique Press the inner mold into the concrete. push the inner mold down into the center of the concrete. make sure to set the inner mold down far enough to create adequate depth for plants' roots, but also leave about an inch thickness for the bottom of the planter. brie goldman. Mix a batch of quick setting concrete, according to the directions on the package. add concrete color at this point, if desired. 5. pour 2 inches (5.1 cm) of the concrete mixture into the larger container. poke the pieces of pipe into the concrete, with 3 to 4 inches (7.6 to 10.2 cm) between each pipe. For concrete flower pots, add a generous amount to the exterior larger form until almost filled to the top. then nestle the interior form into the concrete, pushing out excess cement. if using a plywood form, nestle the interior form upside down in the larger shape before adding concrete. this will make a large planting container. Remove the screws from the form and the dowel. gently peel away the sides, as shown, and tilt the planter onto its side. use your drill driver and a ¼ inch bit to loosen the drain dowel, and a hammer and chisel to punch it out. we finished our planter with a water based translucent concrete stain from quikrete.
Comments are closed.