Double Wrapped Ribbon Lei Graduation Leis Diy Ribbons Graduat Honolulu based crafting guru joy shimabukuro (@thejoyofcrafting) of ben franklin crafts shows you how to make a simple braided ribbon lei, perfect for lei da. This video shows how to make single braided ribbon lei with 3 ribbons. i have another two videos with 2 and 4 ribbons. i'm making other hawaiian ribbon flowe.
Graduation Leis Diy Ribbon Lei Lei Ideas This video shows how to make single braided ribbon lei with 4 ribbons. there are other videos with 2 and 3 ribbons. i'm making other fancy ribbon flowers vid. Insert the second ribbon loop (the dark blue) inside the previous loop. pull the previous loop (the light blue) tight. be careful not to pull the loop so tight that the ribbon buckles. you want the loops to secure each other, but still have the ribbon lei lay flat. Stick the shiny ribbon through the non shiny ribbon to start the pattern of the shiny side showing on the lei. 3. pull on loop #2’s end to tighten it around loop #1. pull lightly on the loose end of the ribbon you used to make loop #2, watching as the ribbon tightens around loop #1. Pull at least 6 8 inches of each ribbon free from the spool. 2. decide which ribbon you'll start with. this is now ribbon one (red in the example). make a slip knot in ribbon 1, 6 8 inches away from the end. 3. make a little bunny ear stye loop 6 8" along ribbon 2 (white in the example). 4.
Ribbon Lei Double Braid Ribbon Lei Graduation Leis Diy Haw Stick the shiny ribbon through the non shiny ribbon to start the pattern of the shiny side showing on the lei. 3. pull on loop #2’s end to tighten it around loop #1. pull lightly on the loose end of the ribbon you used to make loop #2, watching as the ribbon tightens around loop #1. Pull at least 6 8 inches of each ribbon free from the spool. 2. decide which ribbon you'll start with. this is now ribbon one (red in the example). make a slip knot in ribbon 1, 6 8 inches away from the end. 3. make a little bunny ear stye loop 6 8" along ribbon 2 (white in the example). 4. 10. go down to the spool end of the thread and cut it free, leaving about a foot extra. thread this through your needle, tighten the ribbon as much as possible, and then secure the thread in the same manner you used in step 9. 12. cut the spool ends of the ribbon free, leaving at about 18" of additional ribbon. 13. Step six. once your lei reaches your desired length, slip the ends of the ribbon through the loops and pull tight. knot or sew the ends of the ribbon together to create the lei. create a bow to tie onto the joined portion of the lei. you can see the braiding process in action in this video.
Comments are closed.