Properly framing your photos, posters, and other artwork is more than just putting it in an off the shelf frame there are many tricks that professional fram. Measure the dimensions of the photo you want to frame. cut four pieces of wood to make the edges of the frame. use a miter saw or miter box to cut the ends of each edge at a 45° angle. create a small recess on the inside of the frame using a straight bit to ensure the glass stays in place.
That's where the art of framing comes into play. here are ten expert tips to help you master the art of framing, professionally displaying and preserving your artwork. 1. select artwork with care. before you start picking out frames and matboards, you need to give careful thought to the artwork you intend to display. Hammer: use a hammer to secure nails and picture hangers into the wall where the framed art will hang. 2. measuring tape: use a measuring tape to make sure your frame is at the right distance from the floor. generally, the midpoint of a framed piece of art is approximately 60 inches from the floor. Over time art can become stuck to the glass, ruining the art if you try to take it out of the frame. of course, a mat will also provide a gap, but if you’re not going with a mat, spacers will do the trick. 2. make specialty diy cuts or float your art with mats. in the world of mat boards, a blank mat differs from a window mat in that it’s. Mark your lengths. mark slightly bigger than you need so you can trim to fit. measure the frame moulding from the inside of the rebate (the tab of material that sticks out at the bottom of the moulding. once the frame is put together, the rebates make the aperture that holds the glass and art in place).
Over time art can become stuck to the glass, ruining the art if you try to take it out of the frame. of course, a mat will also provide a gap, but if you’re not going with a mat, spacers will do the trick. 2. make specialty diy cuts or float your art with mats. in the world of mat boards, a blank mat differs from a window mat in that it’s. Mark your lengths. mark slightly bigger than you need so you can trim to fit. measure the frame moulding from the inside of the rebate (the tab of material that sticks out at the bottom of the moulding. once the frame is put together, the rebates make the aperture that holds the glass and art in place). Start by measuring the width and height of your space. next, multiply each by 0.60 and 0.75 to get the smallest and largest total artwork width and height that your space can accommodate. finally, subtract the artwork dimensions from these ranges, and divide by 2. this will give you a range for how narrow or wide your framing should be. Shave off more of the mat if necessary. measure the art to see how large you want the mat opening to be. use a pencil and ruler to outline the opening on the mat, then cut it using an x acto knife.
Comments are closed.