Air in a cooling system can cause overheating problems which can lead to engine damage. it can also prevent your heat from working properly. in this video, i. 3. put a funnel in the radiator and fill it with coolant. use a flashlight to look inside of the radiator. if there’s any room below the “fill” line on the inside, insert a funnel into the radiator cap opening and pour radiator fluid in. continue pouring fluid until you see it inside the stem of the funnel.
In this video i show how to bleed and fill a cooling system using a cooling system vacuum filler. the particular vacuum filler i am using in the video is a. Step 2 turn on the engine. leave the radiator cap off, turn on your engine, and let it run until the radiator bleeds out air. it may take between 15 and 20 minutes for the engine to heat to the proper temperature and begin cycling coolant through. you'll observe the coolant level drop as the air is cycled out, and see air bubbles escaping. Step 8: refill coolant if necessary. close your air bleeding valves. let your engine idle again and recheck and refill the coolant level and lower the front of your car. at this point, you should repeat these steps until you get heat inside the car and your coolant temperature reaches 90c and stays there. For more diy and how to videos, be sure to subscribe to my second channel: m. c fixthishousehi friends! welcome back to the my cha.
Step 8: refill coolant if necessary. close your air bleeding valves. let your engine idle again and recheck and refill the coolant level and lower the front of your car. at this point, you should repeat these steps until you get heat inside the car and your coolant temperature reaches 90c and stays there. For more diy and how to videos, be sure to subscribe to my second channel: m. c fixthishousehi friends! welcome back to the my cha. Keep a close eye on the coolant level in the funnel. it may rise, as coolant expands under heat and pressure, or it may drop as it cycles and air bubbles escape. if your coolant level drops below full, top it up with more coolant and continue the burping process. 5. shut off the engine and top upof the coolant. Let the car run it for a few minutes, even up to operating temperature to open the thermostat and get the water through the whole system. once that’s done, let it cool and then drain. if there.
Keep a close eye on the coolant level in the funnel. it may rise, as coolant expands under heat and pressure, or it may drop as it cycles and air bubbles escape. if your coolant level drops below full, top it up with more coolant and continue the burping process. 5. shut off the engine and top upof the coolant. Let the car run it for a few minutes, even up to operating temperature to open the thermostat and get the water through the whole system. once that’s done, let it cool and then drain. if there.
Comments are closed.