How To Remove Door Panel 2005 Silverado 99 06 Silverado Gmc S 1a auto shows you how to remove or replace the interior door panel trim on your vehicle. you need to remove the door panel for a number of different repairs,. Quick instuctions for 1999 2006 (2007 classic) chevrolet silverado and gmc seirra 1500 2500 3500 trucks, chevrolet tahoe suburban & gmc yukon yukon xl.
How To Remove Door Panel 99 06 Gmc Sierra Youtube I removed the rear door panels but never the front. as you see i was sort if unsure on how the switch cover uninstalled. instead of watching videos on how. Step 1 :detaching the door lock1:08. remove the trimming around the door lock, and pull the back side of it towards the rear of the vehicle. wrap the screwdriver in a rag so as not to scratch the paint, and work it underneath. there are two clips, and they pop pretty easily. pull on it slightly with your hand while prying with the screwdriver. Step 1 :remove the door panel. 1:10. use a screwdriver and a cloth to pry up the trim plates on the door panel. remove the torx screws. unclip the door panel and unplug the wiring harness. for more in depth instructions, see our other videos. step 2 :remove the door inner door handle. 3:15. unclip the door lock rod. Pry out the door handle bezel and set it aside. pull the courtesy light out and disconnect the lead. remove the door panel. step 2 :install the door panel. 2:32. thread the wiring through the panel. secure with the two 7 mm bolts. connect your courtesy light and clip it in. do the same with your power lock switch and power window switch panel.
How To Remove Door Panel Chevy Silverado Gmc Sierra 99 07 You Step 1 :remove the door panel. 1:10. use a screwdriver and a cloth to pry up the trim plates on the door panel. remove the torx screws. unclip the door panel and unplug the wiring harness. for more in depth instructions, see our other videos. step 2 :remove the door inner door handle. 3:15. unclip the door lock rod. Pry out the door handle bezel and set it aside. pull the courtesy light out and disconnect the lead. remove the door panel. step 2 :install the door panel. 2:32. thread the wiring through the panel. secure with the two 7 mm bolts. connect your courtesy light and clip it in. do the same with your power lock switch and power window switch panel. Notice the bottom of the triangle area at the top of the pic. then insert your body tool under the bottom edge of the panel at the upper (front) end of the arm rest that has the window switch and lock button in it and carefully pry it loose. unplug the switches and set aside the switch panel. 2 remove the control panel in front of the arm rest. if you look along the bottom edge you will see two small holes. that's where the two metal clips are that hold it down. again a small screwdriver was used to press in the clips and pry up with. 3 the door lock slide lever just pops straight out of the hole.
Comments are closed.