How To Repair Replace 3 Handle Shower Valve Youtube Steps for 3 handle shower faucet replacement. shut off the water at the main water shutoff. put a drop cloth in the tub to protect it from any work and also to prevent small parts from falling down the drain. remove the handles from the valves using the screwdriver. they’re usually under small covers that read “hot” and “cold.”. Ask this old house plumbing and heating expert richard trethewey repairs and replaces a leaking shower valve.subscribe to this old house: bit.ly subsc.
How To Replace Shower Valve Step By Step Tutorial Quick tips on how to remove old shower stems, handles, tub spout and replace with new. don't forget to subscribe thnx new danco tub shower remodel kit htt. This old house plumbing and heating expert richard trethewey fixes a faulty shower valve with new valve stems and seats. (see below for a shopping list, tool. 1. cover the shower drain with a washcloth. stretch the cloth over the drain so it is blocked completely. this will prevent screws or other small parts from falling in while you work on the valve. as you remove screws or other parts from the shower, keep them in the same place to avoid losing them. 2. Step 7 replace the cartridge. finally, reinstall the cartridge in the reverse order that was used to uninstall it. then, you can replace the handles of the faucet and turn the water back on. the new diverter stem valve should now function properly and direct the flow of water the way it was intended. if your three handle shower faucet is not.
Delta 3 Handle Shower Faucet Repair Kit Bruin Blog 1. cover the shower drain with a washcloth. stretch the cloth over the drain so it is blocked completely. this will prevent screws or other small parts from falling in while you work on the valve. as you remove screws or other parts from the shower, keep them in the same place to avoid losing them. 2. Step 7 replace the cartridge. finally, reinstall the cartridge in the reverse order that was used to uninstall it. then, you can replace the handles of the faucet and turn the water back on. the new diverter stem valve should now function properly and direct the flow of water the way it was intended. if your three handle shower faucet is not. Clean the valve body thoroughly, removing any debris or old sealant. apply a small amount of plumber’s grease to the o rings on the new cartridge. align the cartridge properly. the hot and cold sides should match the valve body. insert the new cartridge into the valve body, pressing firmly but gently. Remove the screw at the end of the stem and install a new washer. be sure the replacement washer is an exact match and coated with petroleum jelly. find the o ring and swap it out with a new one as well. be sure to coat the new o ring in petroleum jelly. screw in your new stem and add the handle hardware back in place.
Comments are closed.