How To Replace A Craftsman Zero Turn Riding Mower Ground Driv This video from sears partsdirect shows how to replace a ground drive belt in some craftsman zero turn riding mowers. the ground drive belt connects the engi. This video will show you how to replace a hydrostatic drive belt on a toro timecutter zero turn lawnmower. this repair is done with with 4 basic tools and do.
How To Replace The Ground Drive Belt On A Zero Turn Riding Lower the mower deck to the lowest cutting position. remove the left pulley cover from the mower deck. push in the blade belt idler pulley and roll the blade drive belt off the left blade pulley. reach under the rear of the mower frame and remove the blade drive belt from the electric clutch. photo: lower the mower deck. I've had this mower for several years now and this is the second time the drive belt needed replace. the first time i had some guy try and tell me it was som. To ensure a safe and damage free removal, follow these steps: wrap as much of the belt as possible around one of the pulleys, making sure it completely wraps around the pulley’s outer cover. gently slide the belt off the pulleys, taking care not to force it. set the old belt aside. Lift the battery out of the battery box. release the seat switch wire harness clip from the seat bracket to create slack in the harness. release retaining tabs and lift the battery box out of the tractor body. set the box on the fender. release the drive belt from the transaxle pulley. pull out the ground drive belt.
Comments are closed.