How To Replace And Install A Shower Valve Cartridge Smarter How To

How To Replace And Install A Shower Valve Cartridge Smarter How To Here’s how: preparing the new cartridge: apply a small amount of silicone grease to the o rings on the new cartridge. make sure the new cartridge is the correct model for your shower valve. inserting the new cartridge: carefully align the new cartridge with the valve body and gently push it into place, ensuring it’s fully seated. Ask this old house plumbing and heating expert richard trethewey travels to seattle to help a homeowner whose shower runs cold whenever there’s a demand for.

How To Replace A Shower Valve Cartridge Put the trim plate and handle back in place. set the trim plate back over the access hole and screw it in place on both sides. if it had a layer of calk securing it around the sides, apply a new layer. screw the shower handle back in place, turn it on to make sure it works, and remove the cloth from the drain. To replace a shower cartridge, start by turning off the water supply and draining any remaining water from the faucet. use a hex wrench to remove the handle and unscrew the escutcheon to access the cartridge. if there is a chrome sleeve, unscrew or pull it out. use a screwdriver to remove the retaining clip holding the cartridge in place. Reattach the trim plate and shower handle. slide the trim plate over the stem of the shower valve and secure it with screws. secure the handle or handles with the set screws. remove the drop cloth and debris. test the shower handle to see if it properly controls the flow and temperature of the water. Step 2: remove the shower handle with a hex key or screwdriver. the next step is to expose the shower valve by removing the shower handle. typically, a shower handle is secured with a single set.