Ultimate Solution Hub

How To Wire Two Electric Radiator Fans

Ac wiring dual electric fans
Ac wiring dual electric fans

Ac Wiring Dual Electric Fans How to wire dual electric cooling fans. With dual cooling fans, there are two methods for wiring up the relay kit. this is based on the draw from the fans, if the fans are larger and draw more than 15 amps each, it's recommended to install a second relay kit as shown below. for smaller fans, both fans can be connected to a single relay as shown above, and the proper fuse should be.

how To Wire dual electric radiator fans
how To Wire dual electric radiator fans

How To Wire Dual Electric Radiator Fans Yes, you can. but it is risky. the electric cooling fan setup has a high amp draw on start up, which can blow the 30 amp fuse that protects the relay and wiring. most relays have a 30 amp fuse. if this fuse blows, the cooling system goes offline, meaning the engine will overheat. a dual fan setup with a large and small fan. Start your wiring project by taking both of the positive wires from the fans and run them to the yellow wires on each relay (tab 87). then connect switched power (usually from your ignition switch), to the blue wires on both relays (tab 86). next, splice together both black wires from the relays (tab 85) and connect them to the thermostat. How to wire an electric radiator fan relay temp sensor. How to wire electric radiator cooling fans using the alloy works relay and temperature switch kit. this kit can be purchased here: alloyworksplus.

how To Wire dual electric fans To A Toggle Switch
how To Wire dual electric fans To A Toggle Switch

How To Wire Dual Electric Fans To A Toggle Switch How to wire an electric radiator fan relay temp sensor. How to wire electric radiator cooling fans using the alloy works relay and temperature switch kit. this kit can be purchased here: alloyworksplus. 87 (red wire) connects to the positive wire on the electric fan. 30 (other red wire) needs constant 12 volt power from the battery. 86 (gray white wire) goes to the ignition switch. Locate a suitable location for mounting the electric fan. this is typically on the front side of the radiator, but can vary depending on the vehicle. ensure that the fan is securely mounted and positioned to provide optimal air flow through the radiator. determine the power source for the fan. in most cases, this will be the vehicle’s battery.

Comments are closed.