Moen Shower Valve Stop Check Valves And Pressure Balanc Brief video showing the stop check valves and pressure balancing spool locations. discussion about stop check valve adjustments. be sure to comment below i. Valve and escutcheon. removing the 1423 balancing spool: 1. to remove the stop tube (#3), grab ahold of the stop tube (#3) and pull forward until it has been removed. 2. to remove the escutcheon (#2), use a phillips screwdriver to remove the two escutcheon screws (#1). slide the escutcheon plate (#2) off of the valve body (#5).
1423 Balancing Spool 12318 Stop Check Valve Kit For Moen One Han 2. to remove the balancing spool (#4b), use a large flathead screwdriver to unthread the balancing spool (#4b) from the valve body (#5b). this will require about six full rotations before you can pull the balancing spool (#4b) from the valve body (#5b). cleaning the balancing spool: 1. If the spool does not move freely, then the 1423 balancing spool will need to be replaced. for ¾" exacttemp models: note: for ½" exacttemp valves refer to original service manual. verify the shut off valves (check stop kit) are in the open position. this will be a screw in the center of the check stop kit. these should be unscrewed counter. Remove screw holding plaster ground and stop tube guard in place and discard. temporarily install handle. turn on water, pull up on tub spout diverter knob and flush the shower riser for 15 seconds. install showerhead and check system for leaks. if there are no leaks, turn off water and remove handle and limit stop. M core universal valves give consumers more freedom in terms of showering functionality and style in new construction or remodel projects. now, moen is introducing new! 2 series trim options for the m core valve system. 2 series trim offers temperature control capabilities and is pressure balanced, while the 3 series trim offers both temperature and volume control.
Comments are closed.