Nokia 105 ta 1423 charging connector jumper kese kare. Nokia ta 1423 charging jumper ways solution 100%workhello friends is video me nokia ta 1423 me charging jumper solution key bare me bataya gaya hnokia ta 142.
Nokia 105 ta 1423 bsi track jumper solution. Nokia 105 ta 1034 charging ways. if the charging is slow then all you have to do is to check with any other nokia charger, but you have to make sure that the charger is original, as slow charging issues almost always occur with phones using 3rd party chargers. clean battery charging pins and check. clean charging connector pins. Jumper wire. soldering wire. soldering iron. first check nokia 105 rm 1134 charging jack if charging jack have carbon so clean with ctc cleaner before teardown de assemble nokia 105 rm 1134,if problem still same then deassemble nokia 105 and check all related components ways diagram we explain this solution below circuit diagram. Most of smartphones work fine, but some users have complained about nokia 105 ta 1034 not charging properly. some nokia 105 owners thought the problem was with the charger and bought new chargers, but then realized that the problem was not with the charger. in this tutorial, we are going to show you some quick fixes for the nokia 105 ta 1034.
Jumper wire. soldering wire. soldering iron. first check nokia 105 rm 1134 charging jack if charging jack have carbon so clean with ctc cleaner before teardown de assemble nokia 105 rm 1134,if problem still same then deassemble nokia 105 and check all related components ways diagram we explain this solution below circuit diagram. Most of smartphones work fine, but some users have complained about nokia 105 ta 1034 not charging properly. some nokia 105 owners thought the problem was with the charger and bought new chargers, but then realized that the problem was not with the charger. in this tutorial, we are going to show you some quick fixes for the nokia 105 ta 1034. Do not connect to products that create an output signal, as this may damage the device. do not connect any voltage source to the audio connector. if you connect an external device or headset, other than those approved for use with this device, to the audio connector, pay special attention to volume levels. parts of the device are magnetic. Hardware solution: 1. turn on the phone, ensure that the phone has a validsw if not flash a valid sw. 2. rehot or change his fifth emi filter or jumper lcd. now check continuity between display connector to the resistor compounds. if any of then is track missing then make a jumper. if the above procedures doesn’t fix the problem the possible.
Comments are closed.