The oculus quest 2 controller diagram provides a visual representation of the controller’s buttons and features. this diagram highlights the main buttons, including the thumbstick, trigger, grip button, and oculus button. it also includes the tracking ring, which allows the device to accurately sense the controller’s position in three. Introduction. go to step 1. this guide will walk you through the steps to disassemble the oculus quest 2 controller to access the joystick and clean it to remove drift. proceed at your own risk. it is easy to lose pieces and damage the device. opening it up like this will void the warranty if the device is still covered.
Oculus developer center | downloads. This is an easy quest 2 controller teardown and assembly procedure. i walk step by step through the entire process needed to disassemble the controller do. Tools: a t5 screwdriver, and some sort of pry tool. step 1: open the battery compartment and remove the battery and the label behind the battery. step 2: remove the black face plate. there is a lot of adhesive, so a heat gun would likely be helpful, but i don't have one. step 3: remove all of the screws in the battery compartment (4) and under. Step 15. part of the side shell is looped around a screw post. in this step, you’ll spread the screw post apart enough to slip the shell out. insert the flat end of a spudger into the gap between the controller ring and the front shell. the front shell is the plastic frame part below the front trigger.
Tools: a t5 screwdriver, and some sort of pry tool. step 1: open the battery compartment and remove the battery and the label behind the battery. step 2: remove the black face plate. there is a lot of adhesive, so a heat gun would likely be helpful, but i don't have one. step 3: remove all of the screws in the battery compartment (4) and under. Step 15. part of the side shell is looped around a screw post. in this step, you’ll spread the screw post apart enough to slip the shell out. insert the flat end of a spudger into the gap between the controller ring and the front shell. the front shell is the plastic frame part below the front trigger. Overview of the unreal touch input mappings. Remove 4x p0, 4.8 mm long screws. remove 2x p0, 10.7 mm long screws. the arrow points to the bluetooth antenna. to disconnect see step 5 of the guide. go to picture 2. to disconnect the cable, slide a thin, esd safe pry tool or tweezers under the metal neck of the connector and lift straight up from the board.
Overview of the unreal touch input mappings. Remove 4x p0, 4.8 mm long screws. remove 2x p0, 10.7 mm long screws. the arrow points to the bluetooth antenna. to disconnect see step 5 of the guide. go to picture 2. to disconnect the cable, slide a thin, esd safe pry tool or tweezers under the metal neck of the connector and lift straight up from the board.
Comments are closed.