2016 Audi A6 A7 3 0 Tfsi Path To Oil Separator Page 2 Audiworld Forums This is a series of videos on how to replace the oil separator on the 2016 audi a7 3.0 tfsi quattro with the crec v6 engine. this has to be the same with the. Received 10 likes on 7 posts. bleeding coolant system after hose replacement. hello! i am about to replace the hose that's under the coolant expansion tank on the driver side as it's leaking at the point of connection with the tank. it's a $17 hose and it's pretty accessible. i couldn't find diy able methods on how to bleed the system after.
Part 01 Before Disconnecting The Battery For Repairs Audi A6 A7 Drain coolant. 1. jack front end of car up enough to fit a bucket under the car, on the left side of the radiator core. 2. place bucket under the lower radiator hose at the core. 3. remove reservoir cap. 4. (3.0l only) locate drain cock on lower radiator hose, near the core: 5. You need to pull out heater hose to expose the bleed hole. the plastic plenum cover need to be removed to see it. bleed two holes on the super charger first one at a time and close the bleed screws. then bleed the hole on the heater tube to the heater core. @ 06 a6 quattro 3.2l fsi traded @185k in 16. Water pump for 3.0t v6 (supercharged) for b8 s4 and s5 water pump for 3.0t v6 (supercharged) for b8.5 s4, s5, a6 and sq5; 3.0t tfsi oil consumption concerns. oil consumption in these engines isn’t as big of an issue as it has been with the first generation 2.0t tsi engines, but it’s still a concern that’s been addressed by audi. Genuine audi part # 06e103547ab (06e 103 547 ab, 06e103547ah, 06e103547h, 06e103547s) trim. a6. a7. a7, rs7. a8. q5. q7. s4. s5. sq5. touareg hybrid. fits a7, a7.
Comments are closed.