Pinon Form 3 Instructional

Pinon Form 3 Instructional Youtube This is an instructional video for pinon form 3. Click here to see video of the form. #1 pinon –. 1) start in front position. 2) bow and step out with the right leg. 3) roll your arms out until locked. 4) left leg pulls inward into a cat stance facing 90 o to the left. 5) step forward with the left leg into a half moon stance. 6) perform a #8 block. 7) half moon forward, and front two.

Copy Of Form 3 P1 November 2019 Memo Google Docs Yukon gear & axle pinion depth setting kit usage instructions yukon gear & axle carrier bearing puller tool usage instructions yukon gear & axle dana spicer housing spreader usage instructions yukon gear & axle cross pin shaft lock bolt extraction kit usage instructions yukon gear & axle dial indicator usage instructions . zip locker. Once preload is set install the seal and loctite pinion nut. 12. once the pinion gear is installed, position ring gear and carrier into housing to check backlash. motive gear and motive gear performance ring gear and pinions are developed to be run at .008" to .012" back lash for street gear sets. 13. Pinion depth setting tool. $ 150.00. after many hours of development and testing, we have finally devised a truly universal pinion setting fixture without the use of spools, bars, etc. this tool is quick to set up and is accurate. works on gm – 10 & 12 bolts. early gm, ford 9″, 8.8″ and 7.5″, chrysler 8 3 4″, dana and many others. Use a whetstone to remove any burrs on the mating surface of the ring gear or gear teeth. thoroughly clean the ring and pinion to remove preservative oil and any metal shavings. air dry or wipe with a lint free cloth. disassemble rear end as required to remove center section (or 3rd member).

Fillable Online Listing Forms Form 3 Form 3 Personal Information Fo Pinion depth setting tool. $ 150.00. after many hours of development and testing, we have finally devised a truly universal pinion setting fixture without the use of spools, bars, etc. this tool is quick to set up and is accurate. works on gm – 10 & 12 bolts. early gm, ford 9″, 8.8″ and 7.5″, chrysler 8 3 4″, dana and many others. Use a whetstone to remove any burrs on the mating surface of the ring gear or gear teeth. thoroughly clean the ring and pinion to remove preservative oil and any metal shavings. air dry or wipe with a lint free cloth. disassemble rear end as required to remove center section (or 3rd member). Deluxe pinion checker 11148. & machine products 4859 convair drive carson city, nv 89706 phone (775) 884 2292 fax (775) 884 3363 web tdmach instructions for the deluxe pinion depth checker kit introduction the t&d pinion depth checker kit is a very accurate method of setting pinion depth in a large number of automotive differentials. Install the proper extension on the dial indicator and calibrate it to zero. the dial indicator extension must contact the pinion head in the area closest to the housing end where the pinion depth tool is mounted; refer to figure 7. measure the pinion depth from the carrier bearing cap surface. move the dial indicator so it contacts the pinion.