Points Condenser Wiring Dia Wiring Diagram Step 1: begin by disconnecting the battery to avoid any electrical shocks or damage to the system. step 2: locate the distributor cap and remove it to gain access to the points and condenser. take note of the current position of the distributor rotor. step 3: use a feeler gauge to set the correct gap between the points. Points and condenser (setup wiring, setting gap, cleaning.
Points And Condenser Wiring Diagram Eco Spot This video explains how the ignition points and condenser work.during the video i also mention the importance of dwell settings achieved by setting the corre. Remove the screw holding the condenser to the baseplate. tighten the securing screw firmly it also earths the condenser. when reassembling the distributor, be careful to fit the leads underneath the plastic insulator. if they are replaced above it the points will be earthed and the ignition will not work. The points ignition wiring diagram shows the connections between various components of the system, including the ignition coil, distributor, points, condenser, and battery. the diagram provides a visual guide for technicians and enthusiasts to understand how the electrical current flows within the system. it allows them to trace wires, identify. How to wire points and condenser. wiring points and condenser in an ignition system is a crucial process that ensures proper functioning of the engine. the points and condenser are components of the distributor, which is responsible for distributing the spark to each spark plug at the correct time. here are the steps to wire points and.
Comments are closed.