Pressing Out Barrel Pin Build Your Own Ak Ak47 Youtube Pressing out the barrel pina full 1 hour and 40 minute dvd of all of the videos can be ordered by sending mail to vetteenthusiast at gmail . The barrel had already been drilled and pinned elsewhere so i had to headspace and then measure back and tryand line up the old with the virgin. i must of measured 20 times and layed it out at least 5. i bought an oversized pin from akbuilder and then used an endmill to cut a semi new barrel pin hole and then press the new pin in place.
Headspacing A Non Matching Barrel With An Oversize Pin Build Your Own Ak47, ak 47, ak build, b. gil horman, atlantic firearms, mod outfitters, park city gun club, rifles, firearms related stories build your own ak 47: part 3—populating a factory built receiver. The m72 parts kit, our starting point for the build. for the build itself, i used an m72 parts kit that i obtained some time ago from apex gun parts though, at the time of this writing, they are sold out. these parts kits are also available from numrich for $312. for the receiver, i used an 80% pre hardened blank. My top five ak 47 tools for building a rifle. ak47 trigger guard riveting jig. 5.) ak trigger guard riveting jig. the very first rivets i ever crushed were those holding the trigger guard onto my. During the barrel pressing, we had one 12 ton press running a custom rifle dynamics barrel press tool and one running the ak builder barrel press kit. the gist of this process is that the barrel press tool supports the front trunion while the barrel is being pressed. it’s important not to press the barrel in too far or too shallow.
Comments are closed.