Replace Bathtub Drain Stopper Kd Architects Finally, pull the stopper out of the drain. 2. install the new bathtub drain stopper. first, insert the stopper into the drain. then, use a screwdriver to tighten the screws that hold it in place. finally, use a wrench to tighten the nut that connects the stopper to the drainpipe. 3. test the new bathtub drain stopper. fill the tub with water. Pop up drain stoppers have a lever on the side of the tub that is used to open and close the drain. to put a pop up drain stopper in your bathtub, start by unscrewing the cap on the overflow drain. then, place the pop up assembly over the drain hole and screw the cap back on. next, attach the lift rod to the lever on the side of the tub.
Putting Drain Stopper On Bathtub Kd Architects How to remove 6 different kinds of drain stoppers. How to replace bathtub drain stopper with a lift and turn. Video shows how to remove and replace a bathtub drain stopper. amzn.to 3e4ghdu face plate. amzn.to 3q8lord linkage assembly. amzn.to 3ko. Step 2. remove the knob on the top of the stopper. hold the body of the stopper in place with one hand and with the other hand unscrew the knob by turning it counter clockwise. if the knob will not unscrew, then wrap the rag around the knob and use the pliers to help remove the knob. step 3.
How To Replace Bathtub Drain Stopper With A Lift And Turn Drain Diy Video shows how to remove and replace a bathtub drain stopper. amzn.to 3e4ghdu face plate. amzn.to 3q8lord linkage assembly. amzn.to 3ko. Step 2. remove the knob on the top of the stopper. hold the body of the stopper in place with one hand and with the other hand unscrew the knob by turning it counter clockwise. if the knob will not unscrew, then wrap the rag around the knob and use the pliers to help remove the knob. step 3. Edit: sorry for not being more specific about the fixture: the tub does not have a pop up stopper in the tub floor. the drain fixture is just a grate (can't get a snake through). i assume that the stopper is suspended in the overflow pipe, like tester101's second image. edit 2: after fiddling with the lever more i was still unable to get the. Tighten the upper lock nut against the adapter to secure the new position. reinsert the plunger, threaded rod, and trip lever back into the tub’s drain hole. screw the plate back into place. test the repair by closing the stopper and running some water into the tub. if water still drains out, repeat the process and lower the plunger a bit.
Comments are closed.