It is recommended that metal drip edges be installed at eaves and rakes. the starter course should overhang the eave edge 1 4" to 3 4" and the rake edge 3 8" to 3 4" if drip edge flashing is not used along the eaves or rakes. if drip edge flashing is present, install shingles even with the drip edge or overhang the starter course over the drip. Learn how to properly install drip edge flashing on your roof in this step by step tutorial. we'll show you the correct technique to press it against the fas.
Roof drip edge codes & installation manuals. amerimax drip edge installation instructions [pdf] amerimax home products, inc., 450 richardson dr., lancaster pa 17603, tel: 800 347 2586, website: amerimax . appleton drip edge installation guide [pdf] appleton supply co., 1905 w. haskell st., appleton wi 54914 usa tel: 800 558 3414 website. Using drip edge with a nailing edge approximately 4 inches deep, nail the drip edge to the sheathing every 16 inches. if installing multiple runs of drip edge, lap them by 1 4–1 2 inch, keeping the nail back from the lapped joint. this will allow for expansion and contraction and prevent buckling. 3. install the starter course. A drip edge is an angled metal flashing installed over the roof decking and fascia board. its purpose is to redirect any water from the fascia into the gutters. if you don’t have a drip edge flashing, your basement, porch, siding, eaves, or roof decking can get damaged from excess water. The causeway connecting the house to the new garage in law suite needs a roof. tom silva starts off his roofing lesson with the apprentices by stressing the.
Comments are closed.