Simple Electric Motor Science Project Hello everyone! this is video i want to show you about simple dc electric motor works experiment science project easy 2018 at homemade . all of us hope you. Position the armature in the paper clip loops, with the shiny, uncolored side touching the paper clips. make sure it doesn’t touch the magnet. if your motor doesn’t start immediately, try giving it a start by spinning the wire bundle. since the motor will only spin in one direction, try spinning it both ways.
Kid S Science Projects Instructables The homemade electric motor consists of a c cell battery, two paperclips taped to each terminal of the battery and a stack of 3 small magnets. the wire connecting the motor to the second battery is held in place with tape. figure 22. a simple electric motor powered by two batteries connected in series. Build a simple electric motor with just a battery, magnet, paper clips, and coil of wire in this fun science experiment! written instructions are available o. Instructions and materials for each of these easy motor demonstrations are available on the science buddies website:1. homopolar motor (version 1): w. 1. bring a magnet close to the coil. once a current is flowing through the coil, it can interact with a magnet. either hold the magnet close to the coil, or tape it to the battery right underneath the coil. the closer the magnet is to the coil the stronger it will interact. [8] 2.
How To Build Simple Dc Motor Video Science Fair Project Ideas Instructions and materials for each of these easy motor demonstrations are available on the science buddies website:1. homopolar motor (version 1): w. 1. bring a magnet close to the coil. once a current is flowing through the coil, it can interact with a magnet. either hold the magnet close to the coil, or tape it to the battery right underneath the coil. the closer the magnet is to the coil the stronger it will interact. [8] 2. Take 2 small balls of modeling clay and cover the sharp ends of the needle. place the needles upright next to the terminals of each battery so that the side of each needle touches one terminal of the battery. use electrical tape to secure the needles to the ends of the battery. your coil should be hanging above the battery. Attach one neodymium magnet to the positive side of the battery labeled 4. the positive side is marked with a " " on one end. center the magnet over the battery. attach four magnets on the negative side of the c battery. these magnets should have the same polarity as the magnet that is already attached.
Comments are closed.