Step By Step Guide On How To Vacuum An Above Ground Pool Submerge the vacuum: place the vacuum head in the water while removing air from the hose. this creates suction. move the vacuum: gently sweep the vacuum head across the pool floor and walls, focusing on corners and steps. empty the filter often: monitor the filter to ensure it doesn’t clog during cleaning. Attach vacuum head to the hose’s swivel end. this is a critical step before you insert the pool vacuum’s head into the water. affix the head to metal fiberglass pole. lower pole hose to bottom of pool. make sure the water return outlet can easily be reached by the telescopic pole. fill hose with h2o.
A Step By Step Guide How To Vacuum An Above Ground Pool Prepare the vacuum: attach the vacuum head to the telescoping pole. attach the hose: connect one end of the vacuum hose to the vacuum head. make sure it’s secure to prevent leaks. prime the hose: submerge the vacuum head and hose in the pool to fill it with water. this helps eliminate air pockets. To vacuum an above ground pool with a sand filter, clean both the skimmer and pump baskets. then set the multiport to filter, and vacuum. when done, empty both baskets again, backwash, and return to filter. the backwash setting will be able to purge the debris that was vacuumed up, leaving your filter in the same state it was in before you. Attach and prepare: connect the vacuum head to the telescopic pole and attach the hose to the vacuum head. place the other end of the hose in the pool to remove air. this ensures effective suction. start vacuuming: move the vacuum head slowly across the pool floor. go in straight lines, overlapping each row slightly. Submerge the vacuum head into the pool, ensuring it's fully underwater. fill the hose with water to remove all air, which is crucial to maintain suction. connect to filtration system. attach the other end of the hose to the pool's skimmer or vacuum point. if using a skimmer, you might need a skimmer adapter plate.
Comments are closed.