How To Tile A Shower Wall And Cut Tiles Like A Pro 16 Steps With Step 8: start laying tile. with the thinset notched, rest the corner of the first tile at the intersection of the layout lines. press the tile into the wall with a slight twisting motion, making sure the edges are aligned with the layout lines. place the second tile next to the first and press it into position. Right after you finish the shower base tiling, tile the inside and outside vertical edges of the curb, measure the length and width of the top of the curb (overhanging the edge by 1 4″ – 1 2″), and order this piece from a stone fabricator. when you receive it, simply attach it with thinset mortar.
How To Tile A Shower Wall Let the first row dry overnight so they can serve as support for the next rows. the last bit of your tiling work should be installing the pieces around your fixtures. cut as needed to install. let. When setting the sidewall tiles, start at the outside edge and work toward the corner [9]. ideally, the outside edge of the sidewalls will start only with full and half tiles. as with the back wall, lay as much tile as you can before making a trip to the saw for cuts. 10. plan the corner cuts for the shower wall. Use some kerdi fix to seal up the holes that were created when attaching the ledger board. when tiling around the tub, you want to leave a 1 8” to 3 16” gap between the tile and tub. the gap will be filled in with silicone later. and by the way, you also want to leave about a 1 8” gap between the tiles in the corners. Use a level and mark a vertical line at the center point. next, mark the height of one tile resting on the shower pan. using this measurement, take a level and mark a horizontal line on the wall. repeat for the remaining two walls. using the horizontal lines as a guide, fasten 1x4s to the walls with 1 1 4 in. screws.
Comments are closed.